Die Cast

To remove oil and chips from ID areas of die-cast pneumatic valve body components, cleaning 500-pound loads in 24” by 18” by 15” baskets, over 500 cubic feet per hour.

Machine:

VAR Immersion Parts Washer

Process:

This process uses a VAR washer with an automated handling system that includes a loading, unloading and return conveyor. The system also incorporates an in-tank submerged spray system and a high volume filtration and chip removal system. Parts pass through a four-minute prewash, ultrasonic wash, rinse, sealing rinse and five-station rotating dryer cycle.

This machine ensures that the insides and blind holes of each part are clean and dry despite random loading in baskets.

To clean parts from an inline die casting system following trim, die and punching operations.

Machine:

Mini Drum Parts Washer

Process:

This process uses an LJ mini drum washer with an extended drying cycle and heat packaging, to release die-cast surface gassing prior to heat treating and powder coating operations. Parts go through material handling into the drum, a filtered wash and rinse and a drying cycle.

This small profile machine is designed to work inline, but is also portable.