Aerospace

• Final precision clean, rust prevent and dry assembled air craft bearings prior to packaging
• Meet stringent Millipore and Milligram specifications
• Design to fit into work cells and eliminate transport to and from central cleaning area

To have assembled air craft bearings go through a final precision clean, rust prevention and dry prior to packaging that meets stringent Millipore and milligram specifications and is designed to fit into work cells and eliminate transportation to and from cleaning areas.

Machine:

• LeanClean 360-1 Sonic Rotating Basket Washer

Rotating basket parts washer with Ultrasonics and Jenfab’s unique basket rocking feature allowing basket to oscillate either side of center for more aggressive Ultrasonic cleaning

Process:

Using a Lean Clean 360-1 Sonic model with a rotating basket washer, JENFAB’s unique basket rocking feature that allows basket to oscillate from side to side for a more aggressive ultrasonic cleaning, micron filtration, an ultrasonic (25kHz) immersion wash and rinse with high-pressure submerged spray followed by a fresh water rinse and complete dry cycle.

Cycle:

1. 1. Immersion wash with high pressure submerged spray
   2. Ultrasonic wash
   3. Immersion rinse with high pressure submerged spray
   4. Ultrasonic rinse
   5. Fresh rinse
   6. Super dry

This machine reduces process times and delays caused by central cleaning systems, produces cleaner parts compared to solvent systems and fits into a specified work cell of 3’ by 5’ footprint.

To clean fuel filter cages for aircraft engines by removing oil, cut-off chips, dust and dirt, two baskets of parts every eight minutes, 16 baskets per hour with a low profile machine.

• Clean fuel filter cages for aircraft engines
• Remove oil, cut off chips, dust and dirt
• Clean two baskets of parts every eight minutes, 16 baskets per hour
• Design to fit into Lean Manufacturing work cell

Machine:

• Lean Clean 360-2 Cellular Rotating Basket Washer

Process:

Using a Lean Clean 360-2, a Cellular Rotating Basket Parts Washer washes and rinses parts with immersion and submerged high-pressure spray and finishes with complete dry using recirculating hot-air dryer.

This machine achieves a very low Millipore cleaning standard without the need for ultrasonic cleaning while being a low 6’ x 6’ profile.

To clean silicone and splatter from formed high-nickel strips and complex shapes after laser piercing and welding processes with a machine that replaces solvent degreaser system.

Machine:

• Large Belt Conveyor Parts Washer

Process:

Using an all stainless steel construction 36” Belt Parts Washer with a four tank, solution filtration, 30 PSI power spray system, high volume solution rinses and smart water management that uses single water source. Parts go through a spray pre-wash, spray wash, two spray counter flow rinses, and a recirculating hot-air convection dry.

This machine cleans parts better than a solvent degreasing system leaving no chemical residue on cleaned components.